Garage door won't close: sensor repair in Pleasantville

A garage door that refuses to close is annoying, but it is the safety system doing its job.

Call (914) 984-5254

In short

A garage door that won't close from the remote is most often a sensor problem, not a broken door. In Pleasantville, a technician checks the photo-eyes and wiring, resets the travel and force, and confirms the door reverses on contact before leaving. Don't bypass the sensors in the meantime.

Belt-drive garage door opener on the ceiling rail

Doors that won't close in Pleasantville

Pleasantville is compact, under two square miles, and near the village center houses from the early 1900s have small detached garages at the back of narrow lots. Sensors there are fixed to old wood frames and share the space with everything the family stores. Along Manville Road and Bedford Road, mid-century capes and colonials have single attached garages where the sensors sit at bumper height. On the Mount Pleasant side and near the Pace campus, lots are larger and hillier, with sloped drives that bring leaves and sand to the door. The Saw Mill River valley holds fog on fall mornings, and wet lenses misread until they dry.

Why a garage door refuses to close

  • Door starts down, then goes back up. Something is blocking, or seems to be blocking, the two safety sensors near the floor.
  • Opener light blinks and the door stays open. The sensors have lost sight of each other: a bumped bracket, a dirty lens or a broken wire.
  • Door closes only if you hold the wall button. That is the opener overriding its sensors. It tells you the sensors are the problem, and it is not a way to run the door day to day.
  • Door closes, touches the floor and reopens. The travel or force setting is off, or the floor has heaved and the door thinks it hit something.

What you can safely try yourself

Clear the doorway, clean both sensor lenses, and check that the two sensors point at each other at the same height. A steady light on each side means they can see each other. If one keeps blinking after that, or the wires look damaged, leave it for the technician.

Never disconnect the sensors or move them up out of the doorway to get the door working. They are what stops the door from closing on a child, a pet or a car.

Fixing it properly

Most of these visits are short. Sensors are realigned or replaced as a matched pair, damaged wire is rerun and secured, and the opener's travel and force are set for your door. If the opener is old enough that it has no working safety reverse at all, the technician will say so and explain the options, and nothing is replaced without your say-so.

Around Pleasantville

  • Pace area: Near the university campus, with homes and rentals.
  • Mount Pleasant side: Pleasantville-addressed neighborhoods outside the village with larger lots.

See the full Pleasantville service area.

Leave the door where it is and call.

Springs and cables hold a lot of tension. Don't lift the door by hand or keep pressing the opener; call and we'll book a technician.

Call (914) 984-5254
Call (914) 984-5254